Step 1:

Cut the pvc with a fine toothed saw to the required length. Pipe should be cut square.

Step 2:

Chamfer the edge of the pipe to be inserted at an angle of about 150 to about 1/3rd the wall thickness, using a coarse file.

Step 3:

Make sure the spigot and socket are thoroughly clean and dry.

Step 4:

Insert the pipe into the socket without the seal ring and mark along the pipe, when it is fully inserted.

Step 5:

Fix the rubber ring into the groove without twisting it.

Step 6:

Apply PRINCE jointing lubricant to the chamfered end of the pipe, up to the mark made on spigot or to the socket end of fitting.

Step 7:

Push the pipe firmly into the socket till the gap between the mark on the spigot and socket is about 10mm to allow for thermal expansion.

Note

Every care has been taken to see that the information given in this page is correct and current but is not intended to form any part of any contract.

No warranty is intended to be given or implied in respect of the contents thereof.