Cut the pvc with a fine toothed saw to
the required length. Pipe should be cut
square.
Step
2:
Chamfer the edge of the
pipe to be inserted at an angle of about
15° to about 1/3rd the wall thickness, using
a coarse file.
Step
3:
Make sure the spigot and socket are thoroughly
clean and dry.
Step
4:
Insert the pipe into the
socket without the seal ring and mark along
the pipe, when it is fully inserted.
Step
5:
Fix the rubber ring into the groove without
twisting it.
Step
6:
Apply PRINCE jointing lubricant to the chamfered end
of the pipe, up to the mark made on spigot
or to the socket end of fitting.
Step 7 :
Push the pipe firmly into
the socket till the gap between the mark
on the spigot and socket is about 10mm to
allow for thermal expansion.
Note :
Every care has been taken
to see that the information given in this
page is correct and current but is not intended
to form any part of any contract. No warranty is intended to be given or
implied in respect of the contents thereof.
